AutoAnchor 730 Handheld Remote and Chain Counter with LCD 4m Cable

Easy calibration, 2-speed operation

• 4 metres spiral cable
  
• Electrical protection against back-emf
  
• Rubber over-moulding for shock protection and grip
  
• Stowage on cradle
  
• Operation in parallel with all AutoAnchor products eg toggle switches, foot switches or other control equipment
  
• Connect to DC, AC and hydraulic systems
  
• Rugged cable and connectors with: moulded plug and socket rated to IP67, 2m flying lead from socket for better connectivity, gold plated contacts on plug and socket to reduce corrosion, and socket sealing cap
  
• Counts rope/chain or all-chain rode
  
• AA703 Base Station
  
• Choice of feet, metres or fathoms measurement
  
• Logs windlass operating hours for maintenance
  
• Electronic diagnostics for troubleshooting installation
  
• Auto stop and docking alarm when the anchor is close to docking
  
• Two speed operation

• Model: AA9209
  
• Power supply: 12V or 24V DC
  
• Current consumption: 50mA
  
• Output maximum current draw 12V DC: 3.5A; 24V DC: 3.5A
  
• Output minimum current draw: 12V DC: 10mA; 24V DC: 20mA
  When connecting to a solid state switching or other low current windlass drive,
  a PLC or AC variable frequency drive, a dummy resistor load (Part #9515)
  may be required
  
• IP Rating: IP67
  
• Operating temperature range: 23°F to 140°F (-5°C to 60°C)
  
• Outputs: 6
  
• Rode – Chain Only: Stainless or galvanised steel
  
• Rode – Rope and Chain: Must have a minimum of 10ft (3m) of chain. Chain must be galvanised steel
  Rope should be a good quality nylon anchor rope. Type 66 or equivalent.
  
• EMC Protection/CE: EN60945
  

• One handheld console unit with cradle
  
• One base station
  
• A deck socket with 2m lead
  
• A socket sealing cap
  
• One sensor
  
• 2 magnets
  
• Screws for the cradle and socket
  
• Installation and operation instructions