Wallas Fuel Dip Pipe

#9172528
Warranty Badge - 12-Months
Ships Dec 9 - Dec 20
Calculate Shipping
Australia Wide
includes any items in cart
ONLY $319.00

Seen a lower price? Ask us to beat it

Add Items to Cart

Click on the image above to view full picture

The item you're looking at is currently unavailable or has limited stock, how about this one instead?
Details

Details

Fuel dip pipe

Installation instructions for Tank connection 30011 (accessory)

  • You will need to make a diameter parts 25 mm (1) hole in the upper surface of the fuel tank. Choose the location of the hole so that when the boat tilts the end of the intake pipe will stay in the fuel even if the tank is not full. If the end of the intake pipe does not reach the fuel, the device will quickly choke on the air in the fuel system.

  • Cut the fuel intake pipe ( diameter parts 6 mm) to the appropriate length. The end of the pipe must not touch the bottom of the tank in order to keep water and sediment from the system. It is recommended to cut the pipe short enough to leave the engine intake pipe at a lower level. This way the device cannot empty the tank.

  • Install the pipe straight end first and angle the two ears below the threaded barrel inside the hole and then align the threaded barrel vertically so the ears are hooked on the underside of the tank top. Carefully slip the rubber washer over the bent pipe end and over the threaded barrel, followed by the metal washer and the nut. Thread the nut to the threaded barrel and tighten, sealing the fitting to the top surface of the tank. Silicone sealant can be added if so desired.

  • Connect the fuel hose to the heater.

  • Products You Recently Viewed

    Recently Viewed