CruzPro A60 Digital Ammeter

The A60 Digital Amps Gauge is an accurate digital instrument for electrical current measurement.

High and Low current alarms can be set using the front panel switches. The alarm can be turned ON/OFF with the press of a single key. When activated, the built-in 85 dB alarm will sound and the display will flash.

Works with shunts from 5.0 to 900 amps (not included, available separately). Calibration tables can be selected using the front-panel switches for the selected shunt size.

Displays 0 to 900 amps of current. Resolution is 0.1 amps to +/- 90.0 amps (for shunt size < 90 amps) and 1 amp to +/- 900 amps (for shunt size > 90 amps) at an accuracy of better than +/- 3% +/- 1 digit.

The A60 draws only 0.017 amps and can be left on continuously. Works on 12 or 24 volt systems.

Outputs digital current data in NMEA 0183 serial data line format. This information can be used to log performance or repeat the display information at a remote location on the CruzPro RP60 and/or RP110 data repeaters.

5 levels of backlight (including OFF) can be selected from the front panel.

The units are factory calibrated, if required this can be adjusted over a wide range using the front-panel switches to suit your particular needs. All calibration data is saved to non-volatile memory.

Available with round or square bezels.

NOTE: a current shunt is required for correct operation, sold separately depending on current requirements.

• Operating Voltage: 9.5 - 33.0 VDC, transient protected
• Current Drain: 0.018 amps nominal
• Operating temperature: 32 to 122 deg F (0 to 50C)
• Display: 4 digit LCD, 5 levels of backlighting
• Data: Digital Amps, programmable for 5.0 - 900 amp shunt
• Ranges: 0 to from 5.0 to 900 amps
• Resolution: 0.1 amps for shunt < 90 amps 1 amp for shunt size > 90 amps
• Accuracy: Better than +/- 3% +/- 1 digit Front panel adjustable
• Data Ouput: NMEA 0183 serial 4800 BAUD, $IIXDR,I
• Size: 2.5'' dia X 4.1'' deep (61mm x 104mm)
• Mounting: 2-1/8'' (55mm) round hole