Welcome to our new and updated website! - we hope you like the improvements. Any feedback or suggestions gratefully received - tell us at newtheme@marine-deals.co.nz
NZ Site 1800 154 713
$ AUD
Account 0 Wishlist 0 My Cart
◀ Prev (Wallas Wallas Fuel Filter Set Standard)
Up (Fuel Systems) ▲
Next (Wallas Solenoid Valve) ▶
Wallas

Wallas Fuel Dip Pipe

(0)
#9172528
fuel-dip-pipe-kmw30011-500x500
fuel-dip-pipe-kmw30011-500x500
Wallas

Wallas Fuel Dip Pipe

(0)
#9172528
$319
$329.00
SAVE $10.00!
Ships Apr 18 - Apr 29
Earn 3190 points
30 day no worries return
12 month Warranty

Delivery options

Deliver to:
Auckland 0626, NZ
Estimated: $0.00
2-hour Click & Collect:
(order before 3pm, in-stock products only)
Our Auckland Shop
Free

Buy now, pay later & Finance Options

Find Local Store
Report incorrect product information
The item you're looking at is currently unavailable or has limited stock, how about this one instead?
VETUS 75709VTEB Water Separator/Fuel Filter with CE/ABYC Double 10mic
VETUS 75709VTEB Water Separator/Fuel Filter with CE/ABYC Double 10mic
$199
$499.00
SAVE $300.00!
Fuel dip pipe

Installation instructions for Tank connection 30011 (accessory)

  • You will need to make a diameter parts 25 mm (1) hole in the upper surface of the fuel tank. Choose the location of the hole so that when the boat tilts the end of the intake pipe will stay in the fuel even if the tank is not full. If the end of the intake pipe does not reach the fuel, the device will quickly choke on the air in the fuel system.

  • Cut the fuel intake pipe ( diameter parts 6 mm) to the appropriate length. The end of the pipe must not touch the bottom of the tank in order to keep water and sediment from the system. It is recommended to cut the pipe short enough to leave the engine intake pipe at a lower level. This way the device cannot empty the tank.

  • Install the pipe straight end first and angle the two ears below the threaded barrel inside the hole and then align the threaded barrel vertically so the ears are hooked on the underside of the tank top. Carefully slip the rubber washer over the bent pipe end and over the threaded barrel, followed by the metal washer and the nut. Thread the nut to the threaded barrel and tighten, sealing the fitting to the top surface of the tank. Silicone sealant can be added if so desired.

  • Connect the fuel hose to the heater.

    • Some of our product deals are strictly limited - once they're gone, they're gone! Secure yourself this amazing deal while stocks last...by clicking the Add to Order button above.